The riveting nut produced by the rivet nut manufacturer is a kind of nut that is applied to thin plates or sheet metal. We also call the riveting nut a rivet nut with a round shape and an embossed tooth and guide groove at one end. The working principle of the pressure riveting nut is to press the embossing teeth into the preset hole position of the sheet metal, and then press the flower teeth of the pressure riveting nut to squeeze into the plate, so that the periphery of the preset hole will be plastically deformed, and the deformation will be squeezed. Into the guide groove, and then the locking effect occurs.

1. When we install pressure riveting series such as steel or stainless steel pressure riveting nuts, we must ensure that the aluminum plate we want to install has undergone surface treatment or oxidation.

2. In order to prevent the reduction of the fastening metal used to make the pressure riveting fasteners and the board strong, we should not remove the burrs of the stainless steel nuts and other fasteners during the installation, because this is not conducive to the fastening operation .

3. Don't install our pressure riveting fasteners at a place shorter than the required distance between nuts, studs and other fasteners from the edge of the board.

4. Before we proceed with the installation, we must find a suitable installation force. If our installation force is too large, the heads of our nuts and other fasteners will be flattened, and even the threads will be broken and twisted. And deformation

5. When we install pressure riveting nuts and other stainless steel pressure riveting fasteners, we cannot use a hammer to install it, because it is impossible to make our fasteners and the plate have a strong connection.

6. In order to make the force of the stainless steel and other fasteners point to the plate, we need to install the screws from the opposite side of the head of the pressure riveting fastener.

7. When we install fasteners on the board, we need to ensure that its surface does not need to be pre-coated.