Stainless steel rivet nut is a tool widely used in various production industries, which is indispensable to the production industry. Let's introduce stainless steel rivet nuts.

Stainless steel rivet nut

The pneumatic or manual riveting gun can be riveted at one time, which is convenient and firm; It replaces the traditional welding nut, and makes up for the defects of metal sheet, thin tube welding fusibility, and welding nut irregularity. The products have emerged through the survival of the fittest, and today's manufacturers are not satisfied with the status quo, but continue to innovate with the development of technology, which has been widely used. At present, many manufacturers produce secondary products. In order to use them more safely and safely, you must read the relevant instructions before using them. Products are not only applicable to one industry, but are applied by many industries.

The difference between stainless steel rivet nuts and traditional welded nuts: with the development of science and technology, the nuts are also constantly updated to repay the loan. If the stainless steel rivet nuts need to be installed outside, and the internal space is small, and it is impossible to allow the pressure head of the riveter to enter for riveting and sprouting, and other methods cannot meet the strength requirements, then riveting and expanding are not feasible. It must be riveted by pulling. It is applicable to the fastening of plates and pipes (0.5MM-6MM) of various thicknesses.

If the stainless steel rivet nut is tightened too tightly, it will also rust the interface, which is not conducive to disassembly. It is recommended to tighten the nut by hand first, and then use a wrench to tighten the nut for half a turn to one turn. When installing the car tire, the screw should not be too tight, otherwise the screw may be deformed and the fixing effect may be affected. On the same tire, the tightness of each screw should also be average, and no individual screw should be tightened too tightly, otherwise the driving of the tire will be affected, and in serious cases, the screw may be broken due to uneven stress. When screwing the tire, it is best to ask a professional. If you do it yourself, tighten it one by one according to the diagonal sequence. Each screw should be applied several times and gradually. The screw can only be "strong". Do not tighten it to the end at one time.